Difference between revisions of "Tutorial ODS modal"

Rename you the .cfg file to your kipper and put them in the previously newly created folder from. Close to the window with "Save":

==Create geometry  ==     

The individual ways can be looked up in detail in the OROS Modal manual. The structure in this example is as follows:

==time data in NVGate==  

   

Activate the required channels with the recorder and configure the sensors as usual. In addition , the point to be measured and the measuring direction of the sensor must be specified in the “Channel connection properties”. This must be adjusted after each measurement until all measuring points have been measured. In our example, input 1 always remains in the same place as a reference , the second moves away the other points in the structure.

==Recorder settings==

The “Start to time” function ensures that all time measurements are exactly the same length at all points. If these are not of the same length, OROS Modal cannot process the data.

   

It is important to adjust the node information (Node) and the measurement direction (Direction) in the "Channels connection properties" after each measurement:

These functions can also be added to the Control Panel for faster access:

You can reach the “Customize Control Panel” menu by right-clicking in the Control Panel. Then create a new layout with the button marked in the middle of the window and then select the desired “Settings” and add them to the window using drag & drop. Then confirm with "OK".

Now make the different time measurements:

   

- "Excitation Mark" -> Unit of Y Axis -> m / s² Then select the UFF files using the "..." button     

Then select the previously created UFF files and click on "Open":   

Then use the "Batch Add" function and confirm with "OK":     

The available data will now be displayed. Errors in the excited nodes or directions can be made here, then confirm with "OK":

==Show result==