847
edits
Difference between revisions of "Balancing single/dual plane"
Jump to navigation
Jump to search
→Initial run
| Line 370: | Line 370: | ||
After saving the initial run the results are displayed as shown in '''the figure below.''' | After saving the initial run the results are displayed as shown in '''the figure below.''' | ||
[[Image: | [[Image:Bal_1_Init_Result.png|framed|none]] | ||
''Results of Initial run'' | ''Results of Initial run'' | ||
| Line 376: | Line 376: | ||
On this figure, the blue circle, representing the allowed residual unbalance, shows directly after the initial run if the machine meets the required balancing quality or not. | On this figure, the blue circle, representing the allowed residual unbalance, shows directly after the initial run if the machine meets the required balancing quality or not. | ||
''' | '''Note: '''At this point the tables only show amplitude and phase. The unbalance in <nowiki>[</nowiki>g mm<nowiki>]</nowiki> or in <nowiki>[</nowiki>oz in<nowiki>]</nowiki> can only be calculated after the rotor sensitivity is measured in the test run. Click OK to proceed to the test run. | ||
===Test run=== | ===Test run=== | ||