Difference between revisions of "NVGate Virtual Input"

NVGate Virtual Input (view source)

1,195 bytes removed , 09:44, 11 May 2020

8,877

edits

@@ Line 55: / Line 55: @@
 ===Twist===
-The twist measurement consists of computing the angle between the 2 side of transmission shaft (or belt/chain). The measured angle is directly proportional to the stress and the applied torque.
+[[NVGate_Torsional#Twist_measurements_.28static_and_dynamic.29|Read torsional page]]
-The twist can be:
-* '''Static twist''': measure the transmitted torque and power. This is a parameter, not for analysis purpose
-* '''Dynamic twist''': measure the oscillating stress and resonances. This is a dynamic signal to be analyzed.
-Both signals (torsional) are computed simultaneously by the virtual input module.
-For computing the phase between the 2 sides of the twist it is necessary having a tachometer.
-This tachometer can come from any of the inputs or directly from one of the torsional signals using the ''Torsional <nowiki>+</nowiki> tach.'' mode.
-The Twist sub-modules allow selecting each torsional signal from the ''source 1'' and ''source 2'' lists.
-[[Image:Virtual_Inputs_07.png|framed|none]]
-The twist will be displayed in angle or torque. The coefficient is used to convert the read angle in torque.
-The result are available from the add/Remove windows under the virtual input tab.
-====Uncorrelated pulse number====
-Note that any number of pulses/rev can be used for twist computation and these numbers of pulses/rev can either be different on each side.
 ===Tutorial===