Difference between revisions of "NVGate Ribbons: Measurement Tab"

Jump to navigation Jump to search

NVGate Ribbons: Measurement Tab (view source)

Revision as of 13:19, 21 April 2020

286 bytes removed ,  13:19, 21 April 2020
→‎Front-end group
Line 79: Line 79:
=====Front-end group=====
=====Front-end group=====
Control/command of the general acquisition setup.
Control/command of the general acquisition setup.
[[File:front_end group.png]]


*  
*  
[[Image:Reports_Tools_Ribbons_279.png|framed|none]]
[[Image:Reports_Tools_Ribbons_279.png|framed|none
Auto-range (CTRL<nowiki>+</nowiki>SHIFT<nowiki>+</nowiki>A). Controls and start the auto-ranging procedure. ''See Chapter 1 ASB § Front-end/Auto-range for details''
Auto-range (CTRL<nowiki>+</nowiki>SHIFT<nowiki>+</nowiki>A). Controls and start the auto-ranging procedure. ''See Chapter 1 ASB § Front-end/Auto-range for details''
*  
 
[[Image:Reports_Tools_Ribbons_280.png|framed|none]]
*Record signal : Check this box to ensure the recording of all active inputs. This includes the DC inputs (parametric), the Ext Sync. and the CAN ones.
Check ICP: Checks if an ICP transducer is correctly connected to each input for which the coupling is set to ICP. It measure the DC polarization voltage through time averaging and opens a window with the results:
Unchecking this box just set the recorder to off. The inputs remain set in the recorder. This is helpful to temporarily pause the inputs recording; especially on setup fine tuning.  
* Short circuit: DC voltage <nowiki><</nowiki> 4V (the sensor may be faulty)
* ICP detected: DC voltage between 4V and 20V (an ICP sensor is detected)
* No connection: DC voltage <nowiki>></nowiki> 20V (no ICP sensor is detected), open circuit
* Un-stabilized input: DC voltage was not stabilized after 40 s.
''See Chapter 1 ASB - § front-end/inputs settings for details.''


*  
*  
Line 97: Line 94:


*  
*  
[[Image:Reports_Tools_Ribbons_282.png|framed|none]]
[[File:Sampling.png]]
Control/command the Front-end sampling frequency.
 
Control/command the Front-end sampling high frequency and low frequency.


Note: The plug-in analyzer and the recorder can reduce respective their bandwidths independently. This setting fixes the acquisition time accuracy and fixes the max signal bandwidth. ''See Chapter 1 ASB - § front-end/inputs settings for details.''
Note: The plug-in analyzer and the recorder can reduce respective their bandwidths independently. This setting fixes the acquisition time accuracy and fixes the max signal bandwidth. ''See Chapter 1 ASB - § front-end/inputs settings for details.''
Retrieved from "https://wiki.oros.com/index.php?title=Special:MobileDiff/2436"

Navigation menu