NVGate X-Pod: Temperature probe conditioner

Expander modules

The XPod is a device that can be fixed on OR3X TW analyzer. Each XPod is associated to a block of 8 inputs.

In the connected mode, when an XPod is present each corresponding input can be routed to:

· The BNC input (Standard)

· The XPod connector

First connect Xpod to the analyzer and connect your temperature probes.
Start Analyzer
Start NVGate
Select a DC Input and put in in a "plug in" (recorder, waterfall (for profile)...)

On settings, put:
- "input type" : temperature
- "physical qty": temperature,the type of
- probe: type of probe that you are using. (range will be automatically set.)

Type: For acquisition setup preparation, the XPod presence can be simulated in the office mode:

One XPod type selector is available for each XPod position.

Cold Compensation: Enable or disable the internal cold junction compensation for the corresponding active Temperature Xpod. This setting enables the compensation of the connectors metal junction thermocouple voltage at the Xpod side. It uses the Xpod internal temperature measurement (2 locations/Xpod) to correct the measured temperatures.

Input type : define the X-Pod
Probe: Define the type of temperature probe connected on the XPod:
- Thermocouple : J, K, T, N, E
- RTD: PT100, PT1000, PT100 3 wires

For each type of probe the Temperature range is shown in the “Range” setting.

While using RTDs (PT100 PT1000), the applied current can be selected

(the standard is 500 uA)

This is a standard connection. If you buy a temperature sensor it is already a cable like this :

note : for a 2 wire probe the third pin is optional. It is working with a 2 pin connector.

Some PT100 sensors have "A B B" indicator and not Gnd, - , + . In this case you need to cable the PT100 like this:

"-" is the "black" cable, the current source. It is the biggest pin.

+: is the "white cable" is the point than we measure on the midle pin.

Gnd :(A: red color) is the ground pin.

X pod is measuring beetween "+" and "gnd"