847
edits
Difference between revisions of "NVGate Post Analysis"
Jump to navigation
Jump to search
→Selecting specific ranges
| Line 56: | Line 56: | ||
Once the range is selected, you can run the acquisition by clicking on [[Image:RunIcon.png]]. Only the selected range will be analysed, and you can then save the results : | Once the range is selected, you can run the acquisition by clicking on [[Image:RunIcon.png]]. Only the selected range will be analysed, and you can then save the results : | ||
[[Image:TutoPA_RunUp_Results.png|framed|none]]<br> | [[Image:TutoPA_RunUp_Results.png|framed|none]]<br> | ||
===Conclusion=== | |||
You can now select the Steady state and the Run_down ranges and make the acquisitions. After saving the results, the measurement will appear in the project manager : | |||
[[Image:TutoPA_AllResult_Proj_Man.png|framed|none]]<br> | |||
*'''Note : ''' You can adapt the setup of the result s for each rage if needed (the relevant results for the steady state may not be the same than the Run up and down states). | |||
==Parameters== | ==Parameters== | ||