8,877
edits
Difference between revisions of "Monitoring Solution"
Jump to navigation
Jump to search
→Monitoring panel
| Line 78: | Line 78: | ||
* '''Led: '''Green if the condition is not satisfied (no action). Red if the condition is satisfied (action). | * '''Led: '''Green if the condition is not satisfied (no action). Red if the condition is satisfied (action). | ||
==Installation== | |||
===Package contents=== | |||
* The Monitoring Application: ''MonitoringApplication.exe.'' | |||
* Drivers for the USB/RJ11 reset box. | |||
*'''Install NVGate''' | |||
Install NVGate using "Setup.exe" provided from the NVGate CD. Then, follow the steps until the installation is finalized. | Install NVGate using "Setup.exe" provided from the NVGate CD. Then, follow the steps until the installation is finalized. | ||
*'''Install Monitoring solution''' | |||
The Monitoring solution can be installed using "Setup_Monitoring_X.X.exe". It will create a shortcut on desktop, but also into NVGate "Links" folder in order to launch it directly from NVGate. | The Monitoring solution can be installed using "Setup_Monitoring_X.X.exe". It will create a shortcut on desktop, but also into NVGate "Links" folder in order to launch it directly from NVGate. | ||
The add-on "MonitoringApplication.exe" must be located within the NVGate installation directory. | |||
*'''Install monitoring reset box drivers (if required)''' | |||
Monitoring reset box drivers should be installed automatically during Monitoring installation. | Monitoring reset box drivers should be installed automatically during Monitoring installation. | ||
| Line 103: | Line 107: | ||
* Have disk… | * Have disk… | ||
* Select ser2pl.inf into "Monitoring\drivers" directory | * Select ser2pl.inf into "Monitoring\drivers" directory | ||
===recommended parameter=== | |||
It is recommended to add a shortcut of this monitoring .exe file in the "Link" directory (C:\OROS\NVGate data\Links) to have a direct access from NVGate via the link section. | |||
In order to ensure proper monitoring, it is necessary that both the PC and Monitoring Application are able to be automatically restarted. To do that, create a shortcut of the Monitoring application into the windows startup directory (C:\Users\USERNAME\AppData\Roaming\Microsoft\Windows\Start Menu\Programs\Startup). The monitoring application will take care of restarting NVGate if it is not already running. | |||
===Autonomy box installation=== | |||
The reset box must be plugged into the analyzer<nowiki>'</nowiki>s RJ11 port and the USB slot on the computer. Provided drivers must also be installed. | |||
[[Image:Manual_Monitoring_OROS_02.jpg|framed|none]] | |||
<font color="#1F497D">''Figure 2 - Autonomy box installation''</font> | |||
===PC and windows configuration=== | |||
In order to guarantee a full autonomy, the computer must be configured to reboot in case of a power failure. We advise the following PC parameters be set as below: | |||
<u>'''PC automatic restart due to power failure:'''</u> | |||
To account for a potential power failure at the analyzers location the following settings should be programmed on the PC to automatically switch on the PC once power is restored. | |||
Access the PC<nowiki>'</nowiki>s BIOS: | |||
* Restart PC, press F12 (on most PC<nowiki>'</nowiki>s) to access the PC<nowiki>'</nowiki>s Bios. | |||
* Check the Bios parameters. | |||
On power management check the option "power on AC". | |||