Difference between revisions of "NVGate Front End"

NVGate Front End (view source)

742 bytes removed , 12:14, 5 May 2020

9,040

edits

@@ Line 745: / Line 745: @@
 =====Output settings=====
-Used to control general output behavior. i.e. the signal generated on Out 1 &2 and Aux. Out 1 to 4.
+[[NVGate_Output_Signals#Output_general_settings|Read output page:]]
-* '''Transition time''': The value of this setting is the time it takes for the output to go from 0 to activated level and the time it takes for the output to go from the activated level to 0 when deactivated. This transition time is applied only if the ''Output x/transition control ''value is "On"
-[[Image:front_end_23.png|framed|none]]
-* '''Mute ''''''all''': On / Off: When "On", all the outputs are set to zero. The value of this setting is automatically set is "On" when the ''Emergency Stop ''setting from the same sub-module is pushed.
-'''Emergency ''''''Stop''': Automatically mutes all the outputs when pushed. Use the ''Mute all ''setting from the same sub-module to make the outputs work again.
 =====Outputs=====