8,877
edits
Difference between revisions of "NVGate Transducer and Calibration"
Jump to navigation
Jump to search
NVGate Transducer and Calibration (view source)
Revision as of 08:56, 3 May 2020
, 08:56, 3 May 2020→Transducers Calibration
| Line 177: | Line 177: | ||
* Calibrate: Starts the calibration. The analyzer detects the maximum level, checks that frequency is near the calibrator frequency, and determines the new sensitivity. | * Calibrate: Starts the calibration. The analyzer detects the maximum level, checks that frequency is near the calibrator frequency, and determines the new sensitivity. | ||
[[Image:Reports_Tools_Ribbons_13.png | [[Image:Reports_Tools_Ribbons_13.png]] | ||
NB: In case of 1-DSP analyzer with 4 inputs @ 51,2kHz connected to the octave plug-in, it is not possible to perform the calibration (DSP power limit reached). In such situation, down the sampling frequency to 25,6kHz or disconnecting the inputs from the octave plug-in for the time of the calibration will allow calibrating the sensors. | NB: In case of 1-DSP analyzer with 4 inputs @ 51,2kHz connected to the octave plug-in, it is not possible to perform the calibration (DSP power limit reached). In such situation, down the sampling frequency to 25,6kHz or disconnecting the inputs from the octave plug-in for the time of the calibration will allow calibrating the sensors. | ||
* | * | ||
[[Image:Reports_Tools_Ribbons_314.png | [[Image:Reports_Tools_Ribbons_314.png]] | ||
Detect TEDS: Start the sequence for detecting transducers (or missing one) equipped with an electronic datasheet inside (TEDS: Transducer Electronic Data Sheet) connected to the front end. | Detect TEDS: Start the sequence for detecting transducers (or missing one) equipped with an electronic datasheet inside (TEDS: Transducer Electronic Data Sheet) connected to the front end. | ||