writer
544
edits
Difference between revisions of "ORBIGate Manual User's guide"
Jump to navigation
Jump to search
ORBIGate Manual User's guide (view source)
Revision as of 12:13, 1 December 2023
, 12:13, 1 December 2023→Analysis preferences
| Line 225: | Line 225: | ||
In the preferences, it is also possible to: | In the preferences, it is also possible to:<br> | ||
- '''Sampling frequency''': Select the maximum sampling frequency allowed for the analyzer. Among others, it enables the user to limit the DSP load. Placing the mouse on the “i” icon will give local contextual information. | |||
- '''Gap / Zero & low speed GAP''': Enable the acquisition in the measurement of the Gap at Zero and low speed from ASync analysis. For that: | - '''Sampling frequency''': Select the maximum sampling frequency allowed for the analyzer. Among others, it enables the user to limit the DSP load. Placing the mouse on the “i” icon will give local contextual information.<br> | ||
* | |||
- '''Gap / Zero & low speed GAP''': Enable the acquisition in the measurement of the Gap at Zero and low speed from ASync analysis. For that:<br> | |||
* Corresponding ASync channels should be connected | |||
* ASync analysis resolution is recommended to be set to high resolution to fit the low speed conditions (typically at least 0.625 Hz as set by default). <br> | |||
- '''- Post Analysis playback speed''': It is possible to setup Post analysis signal playback speed in the user preferences: this allows controlling the post processing speed of the results. Increasing playback speed may introduce down sampling of the results collection in the measurement. It will cause results to be collected less often. When the objective is to control the visualization speed of the results it is recommended to use the navigation mode which is designed for that purpose. <br> | |||
[[OBG_Pref_analysis.png]] | |||
''Analysis preferences'' | |||
====Units preferences==== | ====Units preferences==== | ||