8,877
edits
Difference between revisions of "OR3X Hardware Instruments"
Jump to navigation
Jump to search
OR3X Hardware Instruments (view source)
Revision as of 09:59, 24 October 2023
, 09:59, 24 October 2023→Back panel connectors description
| Line 190: | Line 190: | ||
* Daisy chain from Master unit to the next one in cascaded mode (OUT -<nowiki>></nowiki> IN, OUT- <nowiki>></nowiki> IN, etc…) | * Daisy chain from Master unit to the next one in cascaded mode (OUT -<nowiki>></nowiki> IN, OUT- <nowiki>></nowiki> IN, etc…) | ||
* On the Mobi-Pack, synchronization connectors are on the front panel | * On the Mobi-Pack, synchronization connectors are on the front panel | ||
* DC power in XLR connector | * DC power in XLR connector (Not available on ORMP ). | ||
To be plug with the external power supply. | |||
Warning, do not mix the instrument power supply types. | Warning, do not mix the instrument power supply types. | ||
| Line 203: | Line 204: | ||
* Reset. To be used when your analyzer does no respond to any command. Insert a paper clip in the hole and press smoothly. | * Reset. To be used when your analyzer does no respond to any command. Insert a paper clip in the hole and press smoothly. | ||
* Accessory Power supply. This connector provides power supply for external use (transducer, tachometer, etc… power supply). The available voltage and power are: | * Accessory Power supply. This connector provides power supply for external use (transducer, tachometer, etc… power supply). The available voltage and power are: | ||
* <nowiki>+</nowiki> | * <nowiki>+</nowiki>5V, 3W, 1.6 A | ||
* <nowiki>+</nowiki> | * <nowiki>+</nowiki>9V, 6W, 650 mA | ||
* <nowiki>+</nowiki> | * <nowiki>+</nowiki>15V, 6W, 25 mA | ||
* High speed port: Used for connection the CAN bus probe | * High speed port: Used for connection the CAN bus probe | ||
* Ground connection. Use this screw to connect the analyzer to the ground potential | * Ground connection. Use this screw to connect the analyzer to the ground potential | ||