NVGate time shift resampling

Time Shift Resampling with OROS Analyzer and NVGate software

This document intends to highlight internal signal processing of OR3x with regards to phase precision of Time trigger blocks in NVGate. When trigger event occurs in between two samples of acquisition error may be introduced in absolute phase measurement of the acquired Time block (see Picture 1). Enhanced signal processing of NVGate enables to minimize this error by finding start of trigger even with a much higher precision and performing time shift resampling.

---

/ Principles of OR3x enhanced acquisition

a/ oversampled External Sync input

OR3x Front end features 2 External Sync inputs (2 logic inputs) that have integrated pre-divider enabling oversampling of external trigger channel. For instance when Input Front End Sampling is set to 102.4kS/s (40 kHz bandwidth) External Sync 1 and 2 have detection precision equivalent to 6.5MHz (#102.4*64). Trigger event resolution therefore increases from 9.7 micro seconds (sample rate @ 102.4 kS/s) to 151 nano seconds.

b/ Time Shift Resampling

Enhanced signal processing of OR3x enable phase improvement of trigger block by time resampling of acquired trigger block (at sampling frequency) with a resolution of 1/16^th of a sample. This is made according to the External Sync precise start event. (See Picture 2)

---

/ Benefits of Time shift resampling

Signal processing for time shift resampling is automatically engaged when "Time" averaging is selected in NVGate FFT plug in (see Picture 3).

When "Time" averaging mode is selected, precision of absolute phase of the trigger block signal is therefore increased by a factor of 16.

Picture 3: Time domain averaging in FFT

4/ Precision calculation:

a/ Without time shift resampling

Standard absolute phase error calculation without time shift resampling can be determined as follow (worst case where event occurs right after last sample)

Phase_error = (360/2.56)*f/f_e

Where f is the frequency of interest

f_e is the frequency band of analysis

for instance for a total analysis band of 20kHz, maximum error at 10kHz frequency will be Phase_error = (360/2.56)*10/20 = 70.3 deg

b/ With Time shift resampling

Standard absolute phase error calculation with Time Shift Resampling can be determined as follow (worst case where event occurs right after 1/16^th of a sample )

TSR_Phase_error = (360/[2.56*16])*f/f_e

Where f is the frequency of interest

f_e is the frequency band of analysis

for instance for a total analysis band of 20kHz, maximum error at 10kHz frequency will be TSR_Phase_error = (360/[2.56*16])*10/20 = 4.4 deg

NOTE : time shift oversampling does not affect the phase match between channels (10V range, 0 to 20kHz , +/- 0.02deg on OR36-OR38) it only improves absolute phase information of acquired time block.